Home » Knowledge » Content
Product Categories
Contact Us


Phone(WhatsApp): +8615837731566

Tel: 86-377-60568988

Common rail test bench control section

- May 21, 2018 -

The first screen is displayed after controlling the software of the high pressure common rail test bench, which is mainly used to test the injector:

A. The pressure gauge and tachometer are in the upper left corner. The current pressure and speed will be displayed on the table in real time.

B. The temperature column shows the current oil temperature. You can control whether the temperature control function is turned on and the fogging status is also displayed here.

C. In the upper right corner is the system status bar.

D. The middle is the main interface, the left side of the main interface is the working condition selection button

Here are:

1. Seal test, 2, Start test, 3, Full load test, 4, Idle test, 5, Pre-injection test, 6, Custom test

Above the main interface is the injector selection, you can open the drop-down list to select the injector, or click the "Load" button to select in the pop-up selection box.

E. The main interface is the oil display column with oil return and fuel injection value

F. At the bottom of the window are the function keys. The functions of some keys are changed on different screens. The actual operation must be performed after seeing the function labels. The “F1” and “F10” keys are fixed functions.

2. The following is the second meeting,

Only the main interface has changes, you can test the pump, fuel injectors, rails, and more freely adjustable parameters.

Each group of parameters inside it corresponds to a working condition. The working condition can define the parameters by itself and increase the working condition entries. This function needs to be implemented in the parameter settings.

3, the traditional test stand control meet

This interface is relatively simple, mainly to complete the function of the traditional test bench, so that the system can also be compatible with the detection and maintenance of Euro 2 standard equipment.

There is also the concept of working conditions in the interface, which is displayed in the mode column, where the data can be freely edited by the user without a mode for different parameters.

4, new oil amount of significant part

It can display the injector fuel injection quantity or oil return quantity of each cylinder and the dynamic measuring cup liquid level display. Sub-functions need to add the oil module.

5, parameter setting page

A. The general user only needs to select the corresponding parameter group in the target model to meet the work requirements. In the factory parameters, we will add the common parameter group. You only need to select the parameter you need, so there is no special need to move. To the parameter setting section.

B. The parameter setting is suitable for advanced users. You need to be extra careful when deleting, adding, or editing parameters. You can refer to the existing parameter group to set it. For more details, please refer to the relevant setup document that we have.

6, problem analysis, some informative things to help you understand the working principle of the system

7, data report

You can load the sample and then edit it for processing. After editing, you can save the file or print processing.

 If the example does not meet your needs, you can write an example of your own and save it as a file for your next use.